Farmall & IHC Tractors Discussion Board |
Re: International 2400 round baler
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John W. on October 10, 2001 at 06:40:17 from (63.162.252.102):
In Reply to: International 2400 round baler posted by Jason on October 09, 2001 at 13:45:48:
Jason, I have a 2400 myself. It makes good bales, but it is finicky about feeding (very) dry hay. The feed roller ought to be rubber, every 241 and 2400 I have ever seen has been. Check to make sure that the drive for the roller is working (chain is on, sprocket is actually turning the roller, etc.) and that the pivot arms the roller mounts on are free to swing to allow the roller the vertical movement it needs for varying windrow size. Also check to see that the springs that hold pressure on the roller against the hay are on and doing their job. One operational trick that helps in very dry hay: if you get a bale started and then it stops turning (which will cause the hay to start building up on the pickup,) slow the tractor and bump the gate open just slightly. This will usually start the core turning again, and allow the baler to feed. As soon as it gets going, tighten the gate back down. Might have to do this a couple of times, but by the time the bale reaches 2 1/2' or so you won't have any more problems. Just one note on the other replies: I like New Holland equipment. I think it's some of the best hay equipment you can buy. But if someone offered me a New Holland CHAIN TYPE round baler for free, I'd run the opposite direction, fast as I could for as long as I could. Newer New Holland BELT TYPE balers make the best bales I have ever seen.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|