Farmall & IHC Tractors Discussion Board |
Re: Manifold on Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on October 22, 2001 at 08:11:01 from (63.27.17.14):
In Reply to: Manifold on Farmall M posted by Lance on October 22, 2001 at 07:39:58:
You cantry to clean the threads and installing a new pipe nipple might help. The easiest is to weld the pipe to the manifold. Clean the area real good with a grinder. Run the tractor to get everything good and hot. Weld with a nickle rod designed for cast iron and start the engine to help it cool down slowly. New manifolds are readily available and the old ones do wear (rust) out so you are not losing much by welding the pipe in, and it will last a very long time. Use an anti-sieze compound on the pipe to muffler joint to make muffler removal easier.
Follow Ups:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|