Farmall & IHC Tractors Discussion Board |
Re: Questions about MW governors
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny Frisk on October 29, 2001 at 07:37:21 from (12.4.181.2):
In Reply to: Questions about MW governors posted by doug on October 26, 2001 at 17:15:40:
The M&W governor was a reduced friction design of the OEM governor. Had a thrust bearing in it, and used a different linkage to control the throttle valve so It could be more sensitive. All governors were adjustable for RPM's. The M&W added nothing there. In variable load conditions is where they made the most difference. Once the throttle valve was wide-open, You were getting ALL the power You were going to get, whether You had the OEM or M&W governor. There is a "ROCK-IT Governor" advertised in the Red Power Magazine that's the same design as the M&W.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|