Farmall & IHC Tractors Discussion Board |
installing lights
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry on November 11, 2001 at 12:25:23 from (12.87.102.145):
My Utility 300 has been converted to 12v from 6. The old lights are on, but all the switching and wiring is gone. In order to justify my tractor purchase, I promised my wife I will be able to plow snow. As it gets dark early here, I will need to set up something to deal with this challenge. I am sure I need 12 volt lights, right? I havent wired anything, so some advice will be appreciated. Can it handle 2-3 lamps? Where do I look for a main power wire to hook into? Can I run another switch to a back light in order to have that one as a part time? In the store, I see various amperages for switches, which might I need, and will I need a fuse in the line? Thanks, Jerry
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|