Farmall & IHC Tractors Discussion Board |
Re: Re: Re: IH Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on November 11, 2001 at 16:31:32 from (129.37.117.209):
In Reply to: Re: Re: IH Farmall M posted by S-E Michigan Part Timer on November 11, 2001 at 09:24:41:
I guess you are speaking of the thick washer keys that are on the clamp that attaches the clutch release fork to the cross shaft. Yes, if sheared, that would certainly do it. However, I think if unlikely to shear those, as they are real heavy duty. However, someone working on the clutch could have easily left them out, depending on the friction of clamping alone to hold that mechanism, which might work for a short time, but once it slipped, that would be it until you went up in there and put the key washers back. Good thought.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|