Farmall & IHC Tractors Discussion Board |
Re: Weights for front of M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by PatM on November 12, 2001 at 06:10:35 from (65.101.228.72):
In Reply to: Weights for front of M posted by bob on November 11, 2001 at 22:39:45:
Can't speack to lifting 1500 bales on a three point, cause I don't have one. I've got a beat F11B loader on my '43M, and it handles 1500# bales okay. But, it takes 2 men and a boy to steer (no power steering) and it gets awful light on the rear! If you use a loader keep that bale CLOSE to the ground when moving! As close to the ground as you can. I leaned over last winter, and the only thing that kept me from going all the way was the bucket hitting the ground. Get wheel weights in back, at least two on each side, and/or fluid iin the rears.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|