Re: 3pt Hitch Prototype

Posted by Zonie on November 15, 2001 at 20:57:48 from (64.12.104.33):

In Reply to: 3pt Hitch Prototype posted by Alabama on November 15, 2001 at 14:56:44:

I built a 3 point for my H, used 3"X3"X3/8" Angle iron, attached it to the existing draw bar and draw bar mounts, set it up to use 1 4" X 8" cylinder.
I bought the ball and socket ends for the lift arms and added the 3/4" X 2 1/2" barstock to make my own lift arms.
I bought the lift arm pins, ball and sockets, and other misc. hardware at my local John deere dealer (I know beat me with a stick), they were cheaper than any I could find any where else, and I didn't have to pay shipping or have to wait for them to arrive by mail.
I have not taken any pictures yet, nor have I had a chance to test the operation, that will have to wait till I get the engine back together.
Email me if you need any more specifics

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: 3pt Hitch Prototype Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]