Farmall & IHC Tractors Discussion Board |
Re: 1954 Farmall 400 Hydraulic System
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Aaron on November 19, 2001 at 20:06:52 from (205.188.192.33):
In Reply to: 1954 Farmall 400 Hydraulic System posted by DCSMITH on November 18, 2001 at 19:31:54:
You lost me on 3 cylinders, unless your talking about the 2 on the lift arms, I tee'd those 2 together and ran them off of the left port and left it power up only on the valve under the hood, then I ran the top link off of the rear port at the seat, that way if I needed to move other hyd equipment I can hook up to that port for juice, it runs with power both ways, you can use 2 way power on the lift if you want but I don't find the need to, I got screw in breathers at my hyd shop and put them in the other end of the ram that did not get a hose, works great.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|