|
Farmall & IHC Tractors Discussion Board |
Re: Re: Dennys piston kits
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Leadfoot on November 24, 2001 at 05:33:55 from (206.148.80.55):
In Reply to: Re: Dennys piston kits posted by Check the tractor pulling forum on November 22, 2001 at 14:10:28:
I was at the Poor Farmers Campground tractor show(fall) just out side of Fletcher OH,and both Denny and his dad pulled a very fancy Farmall 400(which they towed 3 1/2 miles on a semi trailer)and both times they weren't even close to a "full pull". However there was tractors that looked like they just came out of the field that had full pulls. I don't know if the others were hopped up,but,you know Denny had everything he makes or has stuck in that 400.
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
