Farmall & IHC Tractors Discussion Board |
Trying to identify a loader
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zonie on November 25, 2001 at 18:56:01 from (205.188.193.166):
I'm tyring to identify a trip bucket loader that I'm looking at for possable purchase. The loader may have been painted red at one time but it's really hard to tell for sure. It has a chain drive hydraulic pump inside a rectangular hydraulic tank. The chain drive runs off the pto. The system uses 90 wt gear oil as per the only tag I could find on anything. The trip bucket is very heavy duty, much heavy dutier than most trip buckets I've seen. It has 1"x1" solid steel ribs about every 6" or so around the out side curve of the bucket. The loader arms are straight (will fit a narrow front end only)and are 2 pieces of 2"x3" angle iron welded together. They appear to mount to the rear end housing in some manner. The hydraulic cylinders are one way only and very heavy duty. 3" with about 2" piston shaft. The cylinders mount to plates that look as tho they shold mount to the side of the clutch housing, I think, with a 2" solid steel shaft that goes under the belly. This loader came off of a 1940's(?) cockshutt tractor that came from North Dakota. I'm sorry about the long discription, I took my digital camera with and it just refused to take any pictures! It worked fine after I got home! The farmer wanted $150 for it and it looks complete except for the mounts that go to the rear end.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|