|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Replace Seals on BN
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on December 15, 2001 at 02:17:03 from (63.25.166.122):
In Reply to: Re: Re: Replace Seals on BN posted by Ray A on December 14, 2001 at 05:43:41:
yes the gear does not move might have to make a puller I should have used 1/2 thread rod or samothing like that I used 3/8 figuring that would be a piece of cake but my hy jack didnt move it at all got mad and cut it off as i had another drum next time will use heaver rod and try again just finished a rear on an A and got lucky on both sides probably have had at least 6 rears apart in last 3yrs only had trouble with on drum usually seals leak and the oil helps get the loose i guess all but the one bast good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That’s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn’t get to see much of that town. I was moved off the train fast and on to the dealer’s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
