Re: Bob M, I need some help.

Posted by Bob M on December 18, 2001 at 06:46:53 from (165.170.128.65):

In Reply to: Bob M, I need some help. posted by Bob on December 17, 2001 at 17:32:16:

Bob - An alternator conversion to your backhoe should be a straight forward swap. Use the same wiring diagram as for the Farmall. Only differences:

1 - Remove the old generator voltage regulator. Then connect the "BAT" terminal on the alternator to the wire that had been connected to "BAT" terminal on the old regulator.

2 - If your Ford already has a generator warning light in the dash, locate the wire running from it to the old regulator. Connect that wire to the alternator #1 terminal.

3 - Since the Ford is a diesel there's no ignition coil, hence no need for a ballast resistor.

If you have a wiring diagram for the backhoe and can post it or email it to me, I will provide more detail if you need it. ...Bob M

Follow Ups:

• Re: Re: Bob M, I need some help. Bob 13:04:04 12/18/01 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Bob M, I need some help. Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]