|
Farmall & IHC Tractors Discussion Board |
Re: Well I got me one(finally)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Well its home on December 23, 2001 at 15:39:35 from (208.47.8.37):
In Reply to: Well I got me one(finally) posted by Jack on December 23, 2001 at 06:51:04:
I just got the M home.Three things wrong(that I know of),block cracked on governor side(found a block for 75.00 bucks still in the tractor)and the oil fill hole on the other side has the center stud gone that the cap screws on,and the intake and exaust manifold is gone.My serial number is 183394 and it looks to be an all fuel.Were the heads and/or pistons different from a gas version?I am new to this Farmall game.I just want it to be stout enough to pull in the 7000 lb and under classes 1st gear or 3mph classes comfortably.Thanks fellas.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
