|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: blow-back in diesel engines
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on December 27, 2001 at 12:54:27 from (216.196.12.113):
In Reply to: Re: Re: blow-back in diesel engines posted by jimbo-- on December 27, 2001 at 11:24:43:
Yep they sure do and it also helps to break the engine in under load , the liners are hardend and it takes them some time to seat the combustion forces the rings out against the liners and you also need to build some heat so that the fuel is being burnt other wise unburnt fuel will wash the walls down and now you got problems . I like to break a fresh engine in under light load for a while to check for leaks and yes sometimes i even get one or two and also bring engine tepm up to at least 165 degrees much prefer 185 to 190 and after i get it upthere shut it down and retoqure the head and reset the valves then fire it up and load it to 1/2 to 2/3 rds of full load and let it run for a coupel hours and keep checking it. It is a real good idea to install a new thermostat just to make sure that it will build heat and hold it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
