Farmall & IHC Tractors Discussion Board |
Re: '47 Super A 3-point hitch/drawbar problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on December 27, 2001 at 16:45:37 from (129.37.117.187):
In Reply to: '47 Super A 3-point hitch/drawbar problem posted by J.R. on December 27, 2001 at 08:50:31:
Every 3 pt hitch I have seen for the Super A series requires removing the drawbar. I never thought of mounting the 3 pt over the existing brackets as noted below. That might work, but seems the drawbar would be in the way of the 3 pt, but maybe not. I had a 140 with a 3 pt hitch, and I used a cross bar in the hitch arms for a drawbar and then later had a bracket made so the cross bar was stabilized by the top link so the cross bar would not rotate.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|