|
Farmall & IHC Tractors Discussion Board |
Re: Farmall H engine rebuild questions...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike in SWI on January 02, 2002 at 16:48:59 from (205.188.197.156):
In Reply to: Farmall H engine rebuild questions... posted by Steven@nd on January 02, 2002 at 16:01:44:
I'm in the middle of overhauling an "H". I got a TISCO overhaul kit. I was very satisfied with parts quality. I should mention though i'm in town and the tractor will not be used for pulling or heavy work. I used the 3 7/16" overbore sleeves but the standard flat top pistons. I had .005" milled off head and gasket surface on block was in good shape. I haven't heard much about firecrater or step head pistons so I can't answer that question. As for valve clearance problems I again don't know the answer either. Good Luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
