Farmall & IHC Tractors Discussion Board |
20 Inch Single Guide Wheel
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold H on January 06, 2002 at 17:22:02 from (64.12.107.21):
In the new issue of "Red Power" someone from IA is looking for a complete single guide wheel from a one row high drum picker for a 400 thru 706. The 7:50 x 20 wheel and fork assembly will fit a M thru 1206. To widen his search, this same wheel assembly was used under the following two row picker models: 214, 220, 214A, 220A, 414, 420, 416, and 422. The 416, 422 was also available with a wider fork with either a 10:00 x 16 or a 11L x 16 tire. This wider guide wheel will also fit the M thru 1206 tractors. He should be able to find these assemblies, expecially the one with 7:50 x 20, at most any salvage yard in the Deep South in cotton country. Harold H
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|