Farmall & IHC Tractors Discussion Board |
Re: leaking axle seals on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on January 08, 2002 at 18:51:12 from (216.46.130.44):
In Reply to: leaking axle seals on H posted by Kurt on January 08, 2002 at 17:01:24:
Kurt, I did axle seals on my H in September. It is not a hard job , just eats up some time. Removing the rear wheels is the big part. Loosen the bolts on the hub blocks and slide the wheels off the axel. I did one at a time for stability. I spent some time cleaning the axle and rubbing it down with fine emery cloth. The new seal has to slide along the length of the axle so it needs to be smooth. Remove the four bolts that hold the axle housing cover and slide the assembly off. Clean off the old seal and gasket and replace. I lubed the axle with lots of clean oil to slide every thing back in place. Torque the bolts back on. I wiped the axle clean and washed it off with Varsol. I replaced my wheels using an anti seize on the threads of the hub blocks. This keeps the bolts from rusting in . LOCKTITE makes an anti seize product. I was able to get the seals from my local Case-IH dealer, but they were pricey. Jobbers can find seals and gaskets cheaper. By the time I was done I had used up most of the morning,four hours or so, some can do it quicker, I like to take my time. My old H now has new brake seals, pto seals and axle seals, purrs like a kitten. I have two H's and an M but I like working on the H, the other I have restored and just have hood and grill to paint.. its the old rusty one that is the best tractor of the three..good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|