Farmall & IHC Tractors Discussion Board |
Re: How much damage could it do? H tranny/rearend.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd with update on January 19, 2002 at 15:54:00 from (12.15.56.30):
In Reply to: How much damage could it do? H tranny/rearend. posted by Steven@nd on January 18, 2002 at 16:17:00:
I have the platform off of the tractor and found the culprit bearing with all but one ball still in it. I found the other ball when I drained the oil, it was ground down halfway. Nothing was broken, but I broke a piece trying to get it apart. I will be sure to thoroughly clean the rearend and transmission before reassembly. Also I plan to put new bearings in both sides and maybe the transmission too. Thanks for the input, I will check around for cracks in the case also! Steven
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|