Re: Interchangeable governors??

Posted by Harley de Koning on February 19, 2007 at 04:57:16 from (63.76.227.181):

In Reply to: Interchangeable governors?? posted by Harley de Koning on February 18, 2007 at 14:42:01:

Thanks for the replys everyone. I robbed the governor off of an early model M. I'm not sure of the year. I will try to get the part number off of the weights tonight. They were stamped A1 and B1 also, I'm not sure what that number is I guess. The stud did come out of the housing towards the rear of the tractor, close to the block side. Near as I can tell they would interchange if I swap gears. The 16 tooth gear is a little smaller in diameter. Was there any diffrence in the M and super M governors. This is going on a M, but it has a 4" bore with IH dome pistons, I'm wondering if I dont have a super M engine? How does one tell? Thanks again.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]