Farmall & IHC Tractors Discussion Board |
Re: Sympathy for machinery,
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by karl f on February 24, 2007 at 23:43:08 from (209.23.170.70):
In Reply to: Sympathy for machinery, posted by kirk in ks, on February 24, 2007 at 21:38:02:
we have a problem :) lol well there is a fine line, or large grey area in our case where you are no longer a collector/enthusiast but someone with a real problem. i think as long as the item is either stored or protected to remain functional (or not degrade to a lesser state if it's broken) or you do actually use it and keeping it doesnt cause a health, family or other important hardship, you're fine--keep your priorties in order. it's important to fight back at our throw-away society, unless of course you're holding onto garbage! unfortunately old implements only have value to someone that wants one. many are so worn that they are not rebuildable and should be considered scrap. but it's hard to keep a sense of reality when you are passionate about something. :) and somebody has to fix a few up so the future knows what used to exist! an example of the bad side of saving old stuff: my family has a lot of old stuff sitting around the farm not preserved and while i like the old stuff i'd almost rather see it gone since we cant take care of it and have no use for it, but we also have the bad mindset that its worth a lot when in reality every year that it sits neglected probably has actually started to cost us after 30+ years of sitting taking up valuable land for buildings or crops! and everyone that inquires about anything is run off the place on a rail... this reality check and vent session was brought to you by budweiser and cabin fever... so anyway have fun collecting! -karl f
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|