Farmall & IHC Tractors Discussion Board |
H 4 magneto question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom/Idaho on March 20, 2007 at 09:04:16 from (216.57.174.229):
I am trying to clean and re-build an IH H4 magneto. I have ( I think)taken out all screws and the pieces that go on both ends, but I can't get the rotor to come out. I have the drive member off but can't get the plate that has the pawls behind it to move. I need to remove that plate and pawls to clean the rust so they will move freely and check the bearings. Also does the post the pawls snap on just press out? Looks like it would. I have an I & T Magneto manual that covers testing and re-building this unit, but it does not tell me what I am not doing. Any assistace would be appreciated. Thanks Tom/Idaho
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|