Farmall & IHC Tractors Discussion Board |
Re: 186 Hydro Repower Options
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Sheepdog in NE on March 20, 2007 at 18:57:04 from (67.0.15.105):
In Reply to: Re: 186 Hydro Repower Options posted by Mark in 'sconsin on March 20, 2007 at 14:48:51:
Run it on a dyno and set the HP. The guy running the dyno will be smarter than me. But I think you are on the right track. Not sure if you have to lose the turbo and/or just turn down the fuel. Depends if you have a non-turbo exhaust manifold. The engine from the combine will be what cid? The 1066's we run have 125 ponies at the pto. They have turbos and 414 motors. Maybe the fuel pump could be used off your original motor.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|