Farmall & IHC Tractors Discussion Board |
Yow!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by A. Bohemian on March 27, 2007 at 11:39:59 from (207.170.88.64):
In Reply to: Re: gas in breather oil cup? posted by nspec on March 26, 2007 at 20:12:45:
You don't use the switch to shut 'er off? How DO you shut 'er off? I am confidant you'll find that the owner's manual says to (a) retard engine control lever by pulling it ALL the way back, and allow the engine to idle briefly (this helps prevent "run-on"), then (b) push the ignition button all the way in (or throw the ignition switch, whichever A has) to stop the engine. If your governor allows the engine to be shut off by fuel starvation, it is not properly adjusted, although I don't know if this is really a problem or not. If the engine can still develop enough RPMs to have usable power, probably not. Incidentally, blow-by can most DEFINITELY cause the oil to smell like gas. My used-car-salesman uncle taught me that. It was one of the things he used to decide REAL FAST if the problem was likely to be valves or rings. He could also HEAR the difference, if the engine would run slowly enough! One final word: it is often a waste of time to replace the rings without doing the valves, and vice versa. One component suddenly doing its job effieciently after years of partial failure will often reveal partial failure in the other. Just my opinion, not "the Truth."
Replies:
- Re: Yow! A. Bohemian. 11:50:20 03/27/07
(0)
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|