Farmall & IHC Tractors Discussion Board |
Re: Tom Windsor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Andy Martin on April 03, 2007 at 05:38:25 from (63.123.95.201):
In Reply to: Re: Tom Windsor posted by Steven@AZ on April 02, 2007 at 18:54:55:
Neither are the M, A, B, C, W-4, 6, etc. The full flow oil system dumps all the trash into the bearigs if you blow out the filter. On a bypass system if the filter plugs up there is no harm done. These engines were made for reliability and a bypass system works quite well, look at how many old abused H's and M's are still operating well. When is the last time you pulled the drain plug from a car engine and had to poke a hole in the sludge to get the oil to drain, yet the engine will still run well? I've done that on lots of old Farmalls which must have gone years since the last oil change. Big bearings and slow speeds and an oil bath air filter.
Replies:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|