|
Farmall & IHC Tractors Discussion Board |
Re: Adding a tank to Hydraulic resevoir for Farmal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on April 03, 2007 at 10:57:13 from (64.80.108.53):
In Reply to: Adding a tank to Hydraulic resevoir for Farmall Su posted by Vernky on April 03, 2007 at 10:23:45:
The fill plug is a 7/8" machine thread. Nothing readily available will fit the hole that anyone is aware of. You need a custom machined piece. Either have the existing fill plug bored out and threaded for a 3/8" NPT, or have something made up. For filling, you are correct. You want all of the cylinders completely retracted so that the maximum amount of oil is in the reservoir. This includes the touch control under the gas tank. It should be all the way down.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
