Farmall & IHC Tractors Discussion Board |
Re: TO BOB 424 bumper
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gary in Mozarks on April 06, 2007 at 18:33:21 from (66.43.47.102):
In Reply to: TO BOB 424 bumper posted by SP on April 06, 2007 at 11:10:19:
Ok, I see what you are talking about. I looked up Marshalls on ebay. You want an aftermarket bumper/grillguard like you sometimes see on 8N ford tractors. ( I don't think IHC ever made them) On mine, I need the actual grill. The seat frame was also gone on mine so I built a angle iron frame and mounted an aftermarket seat, but if your frame is good the seat they sell would work. Chain sway stops work but only at one length, If you want to raise or lower your implement you have to readjust the length of the chains so they are tight when it is down. Gary
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|