Farmall & IHC Tractors Discussion Board |
NI 30A Sickle Bar Mower - back heavy?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nawlens Gator on April 09, 2007 at 02:29:46 from (74.230.197.251):
Hooked up a New Idea Sickle Bar Mower (30A - pull type on wheels that I got last week) to my 140. All the weight hanging behind the axle pushes the tongue up and and raises the tool bar. The 140 rear hydraulics lift, but don't push down. Consequently the rear housing and drags the ground making it impossible to move, much less mow. I can either rig a bracket to add a bushhog type of wheel to the back of the mower, or add some kind of weight (I'm guessing 100 lbs or more) to the pull bar or tongue. Are there other options? Anyone know when these Sickle mowers were made? It has several oil/grease leaks. Are gaskets, seals, etc. available for these? Thanks.
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|