Farmall & IHC Tractors Discussion Board |
Recoring Radiator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom Windsor on April 14, 2007 at 11:39:41 from (75.117.78.163):

Last year, I set out to recore a radiator. Many of the bolts came out without difficulty. But, when I got to the bolts that screwed into the cast iron header, 2 of them broke off. Then, it took me 2 hours to bore and attempt to take care of them. I cleaned the threads in one hole and was just fine. The second hole, I broke the tap off in the hole. No way to get it out except to chip chip chip until it was all broken and then the hole was boogered up real good. So, to the machine shop, welded up the hole, bored and tapped and then in business (in machine shop 1 hour) (fortunately he was my friend) So, Now I had 3.5 hours in a broken bolt plus travel time. So today, I set out to core another one. What I did was to clip the heads off every one of the bolts that went into the cast header. Took the core out and got the header on my work bench. When I clipped the heads and removed the core, the bolts extended out about 1/4 inch. SO, I put the heat to them and with the vice grips you see in the picture, spun them all out. Entire project time by my watch 20 minues!!!! It might have worked if I had not clipped the heads off and my time would have been shorter. Isn't heat a wonderment!!! TW
Replies:
Home
| Forums
Today's Featured Article -
A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|