Farmall & IHC Tractors Discussion Board |
(460) check list-long post
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Al L. in Wisc. on April 24, 2007 at 07:27:41 from (207.190.67.77):
In Reply to: Want to join the UTE Club (460) posted by Butch WI on April 24, 2007 at 03:12:24:
Mornin" Butch. Lool to the left column of this web-page under "Research & Info" and click on the "Serial Numbers" link. Research 460 and jot down year and serial numbers to identify the year when you look at the tractor. Then I would add: check oil level and take a sniff before starting the tractor. Check for fluid leaks under the 460. Coolant level, sediment bowl clean; gas tank cruddy on the bottom; hydraulic fluid level; now start the tractor. Check rear rims for rusting through due to corrosive action of fluid. To operate the TA, while driving tractor, give a steady-even pull back to "engage" the TA and "release" the TA the same way, an even push forward of the arm, don"t operate the clutch when doing this! Gauges operating, i.e. good oil pressure; electrical system charging; tack/hour meter operating and accurate hours; gas gauge operational; temperature gauge may only show a "cool" reading if it is like 240/340"s I have owned as they seem to run cool. Gauges are available if gone/not working. Operate all the hydraulics. Do they release and the system not "whine" indicating there are problems with relief valves/screens/pump "hanging up". Stand down wind from the tractor when warmed up and "smell the air" for something that just don"t seem right. Any manual(s) included; chains; other implements available. I also like to know the history of the tractor, i.e. who owned it, where purchased, previous owners, etc. if this is available, that"s just me. Sometimes on this board folks have posted trying to "track down" a particular tractor. I also like to leave my contact info in case sometime down the road, a person finds something that should have gone with the tractor, implement...You will find a lot of great information in the "archives" area of this site - Farmalls, implements, etc. along with knowledgeable folks who can give advise/comments/humor to this Farmallitis affliction. Good luck and keep us posted...pun intended.
Replies:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|