Re: Splitting 230 to replace oil seal

Posted by El Toro on April 28, 2007 at 17:45:25 from (205.188.116.138):

In Reply to: Re: Splitting 230 to replace oil seal posted by Marv on April 28, 2007 at 14:51:25:

I think when you pull the engine, the clutch and flywheel will come too. The clutch disc will slide off that splined shaft as you remove the engine leaving the shaft in place.

Make sure you use a clutch alignment tool or a short splined shaft off a junker when reinstalling the clutch. This will make it a lot easier when reinstalling the engine. If the clutch is close to rivets I would replace it or have it recovered. If the flywheel is rough I would have it ground smooth. Hal

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]