|
Farmall & IHC Tractors Discussion Board |
Re: Well, I went and did it.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gary in Mozarks on May 09, 2007 at 08:15:09 from (66.43.47.79):
In Reply to: Well, I went and did it. posted by Mike CA on May 08, 2007 at 22:32:11:
Good for you, I honestly think you would worry about not having anything to worry about. LOL If scrap iron will bring 300 dollars and the top end close to two, How can you go wrong at 700 dollars? Your time is worth something too and you probably spent 300 dollars running around looking. The guy is being good to you. and you have a good project to work on. Suggestion, pay the guy off before you go buying stuff for the tractor. He deserves that. I agree with the guys here that its probably the mag or fuel. Ive seen alot of old engines that ran with water in the oil. Just eats up bearings.
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
