Farmall & IHC Tractors Discussion Board |
Re: Smoothing out a pasture...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on May 15, 2007 at 16:13:58 from (4.90.2.198):
In Reply to: Re: Smoothing out a pasture... posted by Patrick Martin on May 14, 2007 at 23:36:49:
St. Augustine isnt a pasture grass and not as tough as bermuda so if you are going to try and save that you will have to be more careful. If you can leave strips of it it will spread by runners. If you dont cover it over a couple inches or less I have seen it come up thru the dirt too. We have a fertilize spreader that broadcasts seed. It is a three point hookup and runs off the pto. Bermuda seed is a small seed so if your spreader doesnt have a setting small enough then mix the seed with some dry sand, like mortor sand. Corn meal also works good and isnt as heavy. Lots of conpanies make small broadcast spreaders that would work for seed. I have also put tape over part of the hole to restrict the bermuda seed from pouring out to fast. After the seed is out you might use a harrow over it but I have had good luck just seeding and nothing else. Theres some good hyrid bermuda seed out now thats more like you see on golf courses if you not useing the area for pasture. Panama is the one I sell, real fine texture to it. Lots more expensive than common.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|