|
Farmall & IHC Tractors Discussion Board |
Re: Can HYD system oil can get back in to the eng
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Larry in GA on May 20, 2007 at 17:55:43 from (71.29.150.239):
In Reply to: Re: Can HYD system oil can get back in to the eng posted by El Toro on May 20, 2007 at 14:17:36:
El Toro Thanks for the parts break down it is a lot better than the one in the IT Manual
El Toro you talked about a speedi-sleeve so the new seal has a new surface to rub on. you are referring to the drive shaft seal? With out tearing mine apart is there anything else that might not be in the kit that I will need. I hate to tear it down before finding out if they have what I need and then be down a week or more and at gas prices one trip is one to many. Thanks again for your help Larry
Replies:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
