Farmall & IHC Tractors Discussion Board |
Re: 660 Narrow Front
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on June 07, 2007 at 14:01:39 from (64.80.110.50):
In Reply to: 660 Narrow Front posted by Motorken on June 07, 2007 at 11:58:59:
I suppose it could be done, but it's not as simple as yanking off the wide front and bolting the pedestal to a plate on the bottom. The 660 is a Wheatland tractor. Never had a narrow front. Steering was achieved using an external hydraulic cylinder-assisted drag-link gearbox arrangement if I am not mistaken. 560s came in Farmall and Wheatland versions. Only Farmalls had a NFE. The steering mechanism on the Farmalls is integrated into the front bolster. Way different designs. Like I said, it is probably possible, but not practical or easy.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|