Farmall & IHC Tractors Discussion Board |
Re: 1066 clutch
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on June 16, 2007 at 10:54:21 from (75.19.127.195):
In Reply to: Re: 1066 clutch posted by dallaine on June 16, 2007 at 09:04:54:
Lube pressure at the sending unit somewhere between 10-15 lbs pressure at the bottom plug on the lower leftshould be anywhere from 235-285 myself i like it around 265-275 on a 1066 . If your working with a Deere man that ya had better find a Half arres Red man . My thinking is that ya got a seal or gskt either blowen or not installed . usualy someone that does not know Red tractors and removes the mCV ALWAYS forget to install the O/ RING down on the bottom left as they installed a new gskt but for got the O/RING and almost as soon as ya fire the tractor it blows the gskt then also the loose the SUMP CHECK PLUG AND SPRING OR JUST THE SPRING , this littel spring looks somewhat like a ball point pen spring and it goes on the lower righside behind the MCV. It is best to leave the RED tractors to the RED MECHAICS just like i leave the green tractors to the guys with the yellow stained shorts.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|