|
Farmall & IHC Tractors Discussion Board |
Re: ih 414d compression
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Matthew on January 29, 2002 at 17:17:10 from (64.68.163.9):
In Reply to: ih 414d compression posted by JT on January 29, 2002 at 14:43:35:
Why do you want to check your compression? Is it starting hard? The reason I ask is that in order to check compression on a diesel you have to remove the injector and install a special adapter and gauge. If you suspect your compression is low in a particular cylinder, and it is missing you can determine if your it is a compression problem by taking an injector out of a cylinder that is firing properly and switching it with the cylinder that is missing. If the miss follows the injector, then you have a faltyinjector. If the miss stays in the same cylinder then you have a compression problem. Either rings or valves.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
