Farmall & IHC Tractors Discussion Board |
Re: Will an M pull 2 10ft or12ft grain drills?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron on February 06, 2002 at 07:31:44 from (155.226.255.42):
In Reply to: Will an M pull 2 10ft or12ft grain drills? posted by R Wyler on February 05, 2002 at 13:19:08:
End-wheel drills pull a lot easier than press drills so two of the 10 or 12 ft end-wheel types should be OK for an "M". I grew up in small grain country in North Dakota and the "M" was THE tractor of choice for pulling grain drills (you're up high out of the dust and drilling was nearly always a dusty job) and everybody used press drills. The "M" would easily handle a 14 ft press drill, but I don't think it could handle two 10s. A few farmers who used two 10s on a multiple hitch used a W-9 or WD-9 for power.
Follow Ups:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|