Farmall & IHC Tractors Discussion Board |
Re: transmission oil in a farmall c
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Freddy on February 12, 2002 at 16:56:57 from (205.188.200.164):
In Reply to: transmission oil in a farmall c posted by jimmy on February 12, 2002 at 15:23:29:
There are five (5) plugs on the transmission/rear end/PTO/belt pully. 1. The filler plug located on the top plate just below the guages. 2. The drain plug located on the bottom of the rear end housing. 3. The Oil level plug located on the right side of the rear end back of the axel housing. 4. The inspection plug located on the top of the power take off/belt plully housing. 5. The drain plug for the PTO/Pully located just to the right of center, below what would be the pully shaft, on the back of the housing. If you mistake the drain plug for the belt pully for the level plug you would over fill the housing. The capacity is 5 U.S. Gallons. For tractors w/PTO and 1 quart less for tractors without. Hope this helps
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|