Farmall & IHC Tractors Discussion Board |
Re: Farmall C Leaking Gear Oil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RPM on February 13, 2002 at 14:36:41 from (63.110.182.225):
In Reply to: Farmall C Leaking Gear Oil posted by Pat Stephens on February 13, 2002 at 09:41:38:
Seals for almost all replacements from Case are newer thinner type made of rubber, old original were usually triple lip leather type, check your housing for cracks that it drives into, then inspect for grooves worn into shaft, per side I would advise putting 2 or more new style seals and try and position them slightly in deeper or out and get to different wear surface. Also check the ball bearings to make sure not breaking up, this real problem on older equipment with a lot of time against machine.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|