Farmall & IHC Tractors Discussion Board |
Re: Flywheel Ring Gear Removal A, B or BN
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on February 14, 2002 at 19:16:20 from (128.59.58.152):
In Reply to: Flywheel Ring Gear Removal A, B or BN posted by RAY a on February 14, 2002 at 18:17:29:
Amazing, ain't it, how it looks like a piece of the flywheel but it really does come off? I don't weld so I have to rely on small bottle torches. In my limited experience, propane isn't quite hot enough, but mapp gas works just fine. I raise the flywheel up with the ring gear on the lower half (so as to help keep the heat away from the center of the flywheel where the gear bites) and just start heating around the ring gear. Probably won't get it hot enough to just fall off, but it will tap off pretty easily with just an oak dowel. Before you start this, I'd suggest you dispatch the Mrs. off to the county seat with instructions to buy a tube of relative bearing grease. You should probably give her a list of several stores. Take advantage of her prolonged absence to preheat the oven to 500 degrees, where you will place the gear to get it really good and hot. (Before putting it in, you might want to use a solvent or even detergent, to get any grease, oil and whatnot off of the gear so as not to make the next batch of biscuits taste funny.) Leave the gear in there long enough for it to heat up to the whole 500 and just slip it on. There'll be so much slack it'll go on easily and even hula-hoop around a little bit, but will tighten right up as it cools. An easy, dare I say fun, and satisfying little project. And don't forget to turn the oven off! Scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|