Farmall & IHC Tractors Discussion Board |
Live hydraulics on my H - some answers
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Theman on February 25, 2002 at 07:43:18 from (12.19.86.5):
john d, The pulley is attached to the fan belt pulley with three 5/16 flat socket-head cap screws. There is a spacer ring between them. The fan belt pulley had to be faced to provide a true surface. Bob M, You're right about the potential radial load on the pump input bearing. The Polychain belt will only be 1/2" wide which shouldn't be too stiff or have to run very tight. If a bearing problem develops then I'll go with the pillow block bearings and a coupler. I don't want to add the extra length if it can be avoided. Bruce (WA), The pump output rating is 16 gallons per minute maximum at 3600 rpm. At 1600 rpm intended engine speed and the 1:2 speed increase, the pump will only turn at 3200 rpm. For protection, a 20 gpm return line filter will be added. Higher capacity on the filter is needed when the cylinders of the Saginaw 3-point are on the return stroke.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|