Farmall & IHC Tractors Discussion Board |
806 rebuild
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom T. on March 01, 2002 at 07:00:28 from (64.133.97.147):
My cousin picked up a 806 last year that had seen a lot of use on a cotton farm. He used it rolling hay until it started using so much oil that he couldn't stand it. Fairly nice tractor to have been used in south Alabama all it's life. He seems to think that the problem is only 1 cylinder and he was going to pull it down and put a used piston and new rings in that 1 hole and ask $4500 for it. He parked it in the fence row for now because he is more or less a tractor jockey and he had other tractors to fix that would give him a bigger return on his time. My question is how much will it cost to rebuild if I did it and how much do you think I should offer him. Thanks for any help and info.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|