Farmall & IHC Tractors Discussion Board |
Re: H HELP QUICK!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on March 05, 2002 at 16:12:14 from (216.46.130.62):
In Reply to: H HELP QUICK! posted by Krey on March 05, 2002 at 13:59:22:
Krey, be carefull removing the old seals, you could easily damage the bearing cage behind them. I did two H's in the last year. You need to pick away with picking chisels. Some folk drill a hole in the old seals and insert a metal screw to get something to pull on. I have had the best luck by picking some of the seal out and then collapsing the seal with a punch and yanking it out with a vise grip. Don't get in a hurry, I probably spent the better part of an hour on each seal. I also belong to the school of one seal. The new seals are about half the width of the old ones. The new seal should be flush to the tractor and that is most likely on a different place on the shaft than the original so you get away from the wear marks on the shaft. Some folk like to use two new seals, it can't hurt but it doubles your repair bill. The material in the new seals will out last the old style seal by years and years . You may as well get new brass bushings for the brake shafts as well and then everything will work like new. I had a brake frozen into the tractor, it took three of us about four hours to get it out,soaked it heated it , pried on it, pounded on it , finally a large crow bar against the lip of the brake shaft and a sledge hammer...cleaned the hole up with a dremmel tool ,inserted a new brass bushing and was back in business...be patient removing those seals, the new ones will tap in easily...good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|