Farmall & IHC Tractors Discussion Board |
706 manifolds
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lynn Becker on March 11, 2002 at 07:43:40 from (162.40.118.2):
I am in the process of putting a new exhaust manifold on. I have got the old exhaust and intake manifold apart and was in need of help? Do you need to resurface the face of the intake where the intake and the exhaust bolt together the surface seems a little pitted and seems the old gasket may still be there Maybe a aluminum gasket like goes next to head. I do not have the new manifold and gaskets yet going to go get them this weekend.Thought if I needed to get any machine work done I could do it this week.I got very lucky and did not twist any bolts off.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|