Farmall & IHC Tractors Discussion Board |
To turn crankshaft or not to turn
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on March 25, 2002 at 16:58:05 from (208.42.12.35):
I am in the process of re-assembling a W6 standard I bought last fall as a "tractor in a box". I've pulled all the pistons and I am looking at the crankshaft journals. They all seem to be in decent shape, no heavy scoring or other scarring. There are some very fine lines around the journals, but nothing I can feel with a fingernail or the edge of a thin piece of brass. The number 3 journal has one very slight groove around it. My fingernail can lightly feel it as I pass over it, but it doesn't catch. Also there is no rust or any other rough surfaces on the crank journals. All the con rod bearings were tight. Should I pull the crank and have it turned or will I be ok to re-assemble as it is? Thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|