Farmall & IHC Tractors Discussion Board |
Re: Re: 24 spokes on Regular
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on March 27, 2002 at 16:55:29 from (216.42.122.112):
In Reply to: Re: 24 spokes on Regular posted by Ludwig on March 27, 2002 at 07:46:25:
Thanks everybody for all the posts!I'll try to remember all this trivia.The F-20 I plan to work on first has round spoke fronts and I think it would look and sit best with the spoke 36,s. It has a set of cut-off 28,s "one is eaten up by the calcium" with 13-28 tires.Finally sitting in the shop on level floor,it sits low in the rear.Was orig. a steel wheel,but rubber will be most practical for me. Although I might try to get some steel rears for it just so it could be all original.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|