|
Farmall & IHC Tractors Discussion Board |
Re: IHC Farmall 656
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Diesel Don on March 28, 2002 at 10:41:45 from (141.129.1.112):
In Reply to: IHC Farmall 656 posted by lanny on March 27, 2002 at 18:49:42:
It sounds to me like you have a single auxillary valve on the tractor split into two valves mounted on the loader.My gas 656 had the same set up.What I would do is get an I&T manual for it and check the proceedure for setting the detents on the tractor auxillary valves.Sounds like they are set a little low.I wouldn't recommend adjusting the relief on the loader.I added a second auxillary valve to my 656 because there is quite a bit of restriction going through all the extra piping by having to split the flow through 2 valves on the loader.I could hear the engine labor when I pulled in the auxillary to feed fluid to the loader.
Follow Ups:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
