Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Saginaw 3-point plumbing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by zonie on April 03, 2002 at 21:35:28 from (64.12.106.29):
In Reply to: Re: Re: Saginaw 3-point plumbing posted by Jess on April 03, 2002 at 19:44:10:
I'm assuming that you have a H or a M if you have a belly pump. If this is the case you can run one hose from the pump to each cylinder as long as you use the 2 outlets that are directly opposite each other on both sides of the tractor. I outlet that is offset is a delayed lift out let just plug it. Your other option would be to run one hose from either side to one cylinder and then tee it off to the other cylinder. Either way will work fine, the only difference would be how much the hoses and fittings cost. And how you want it to look.
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|