Re: Cracks in the bores on my H

Posted by Larry W. on April 06, 2002 at 07:08:17 from (216.228.43.106):

In Reply to: Cracks in the bores on my H posted by Steven@nd on April 06, 2002 at 05:55:15:

Steve, A few months ago(seems like years due to the long winter) I had the same problem. would actually seep a little antifreeze. I took my Dremel and ground a little bit on the cracks, mixed up some JB weld, gooped it in, and while still soft, put the sleeves in. It is working just fine. the cracks were in the middle of 2 and 3 cylinder by the way. I have run the tractor quite a bit since, and no problems so far. I don't think it is a major thing, and may be an inherent problem with this block since the dry sleeve walls are so thin and the block casting is also very thin. Good luck.

Follow Ups:

• Re: Re: Cracks in the bores on my H Dick 15:33:38 04/06/02 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Cracks in the bores on my H Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]